PSN-L Email List Message

Subject: Re: shim stock
From: ChrisAtUpw@.......
Date: Wed, 15 Mar 2000 18:44:40 EST

In a message dated 15/03/00 19:46:19 GMT Standard Time, sean@........... 

>  Difficulties with the stainless are that it is almost unsolderable;
>  if you epoxy the hinges, rough up the stainless with 600 grit emory.
>  I use the office paper cutter to cut it into narrow strips.


    If you use the proper stainless steel flux, EN58 austenitic stainless 
steel soft solders quite easily. The flux must be washed off thoroughly 
immediatly afterwards, as it is very corrosive.


    Chris Chapman

Public Seismic Network Mailing List (PSN-L)

[ Top ] [ Back ] [ Home Page ]

Larry Cochrane <cochrane@..............>